Journals
-
Sullivan T., Salawdeh S., Goggins J. 'Displacement-based design of irregular reinforced concrete frame wall building structures’,
Under preparation.
Finnegan W., Goggins J., ‘Numerical simulation of linear water waves’. Ocean Engineering (under review)
-
Goggins J., Keane T., Kelly A. ’The assessment of embodied energy in typical reinforced concrete building structures in Ireland’,
Energy and Buildings 42 (2010) 735–744.
-
Broderick B.M., Elghazouli A.Y, Goggins J. ’Earthquake testing and response analysis of concentrically-braced sub-frames’,
Journal of Constructional Steel Research, Vol. 64, Iss. 9, September 2008, pp 997-1007.
-
Goggins J., Basu B., Broderick B. M., Elghazouli A. Y. ’Investigation of the Seismic Response of Braced Frames using Wavelet Analysis’,
Journal of Structural Control and Health Monitoring Vol. 14, Issue 4 (June 2007) pp 627-648.
-
Goggins J. M., Broderick B. M., Elghazouli A. Y., Lucas, A. S. ’Behaviour of tubular steel members under cyclic axial loading’.
Journal of Constructional Steel Research, Vol. 62, Issue 1-2 (special edition “Behaviour, analysis and design of steel structures”), Jan. 2006, pp 121-131.
-
Elghazouli A. Y., Broderick B. M., Goggins J., Mouzakis H., Carydis P., Bouwkamp J., Plumier A . ’Shake table testing of tubular steel bracing members’,
Proceeding of the Institute of Civil Engineers, Structures & Buildings 158, Issue SB4, August 2005, pp 229-241 (Paper No. 13615) [
10.1680/stbu.2005.158.4.229]
-
Goggins J. M., Broderick B. M., Elghazouli, A. Y., Lucas A. S. ’Experimental cyclic response of cold-formed hollow steel bracing members’.
Engineering Structures, Vol. 27, Issue 7, June 2005, pp 977 - 989.
-
Broderick B. M., Goggins J. M., Elghazouli A. Y. ’Cyclic performance of steel and composite bracing members’.
Journal of Constructional Steel Research, Vol. 61, Issue 4, April 2005, pp 493 - 514.
Conferences
Salawdeh S., Goggins J. ‘Analytical model for the seismic response of cold-formed steel braces’, The 6th International Conference on Thin Walled Structures, 5–7 September 2011, Timisoara, Romania.
Goggins J., Salawdeh S., ‘Direct displacement-based seismic design of single storey concentrically braced frames’, EUROSTEEL 2011, August 31 - September 2, 2011, Budapest, Hungary.
Salawdeh S., Goggins J. ‘Validation of a numerical model for use in non-linear time history analysis of CBFs’, Eurodyn 2011. The 8th International Conference on Structural Dynamics, 4-6 July 2011, Leuven, Belgium.
Finnegan W., Meere M., Goggins J., ‘The Wave Excitation Forces on a Floating Vertical Cylinder in Water of Infinite Depth’, World Renewable Energy Congress 2011, 8-11 May 2011, Linköping, Sweden.
McCaffrey M., Goggins J., Baylor G. (2010) ’The use of embodied energy and carbon as indicators of the environmental impact of reinforced concrete structures in Ireland’,
BCRI Conference, Cork, 2-3 September 2010.
Gavigan D. & Goggins J. (2010) ’Investigation of fly ash from peat fired power stations a cement replacement in concrete’,
BCRI Conference, Cork, 2-3 September 2010.
Goggins J. (2010) ’Stabilised soil blocks – a cost-effective sustainable construction technology’,
BCRI Conference, Cork, 2-3 September 2010.
Cannon E. & Goggins J. (2010) ’The new engineering building at NUI Galway as a teaching tool for structural engineering’,
BCRI Conference, Cork, 2-3 September 2010.
Goggins J. & Gavigan D. (2010) ’Low-cost sustainable construction technology for autonomous buildings’,
International Conference of Structures and Architecture (ICSA2010), 21-23 July 2010, Guimaraes, Portugal.
Goggins J. (2010) ’A study of the embodied energy in typical reinforced concrete structures in Ireland’,
International Conference of Structures and Architecture (ICSA2010), 21-23 July 2010, Guimaraes, Portugal.
Goggins J. ’Requirements for the Assessment of Embodied Energy into Structural Design Codes’,
2010 Joint IABSE-fib Conference, Codes in Structural Engineering Developments and Needs for International Practice, Cavtat, Dubrovnik-Neretva County, Croatia, May 3-5, 2010, Paper No. 320.
Goggins J. & Sullivan T.. 'Displacement-Based seismic design of SDOF concentrically braced frames’,
Proceedings of STESSA 2009 “Behaviour of Steel Structures in Seismic Areas”- 6th International Conference, Philadelphia, USA, 16-20 August 2009, Paper No. 141.
Goggins J. & Broderick B. M. ’Condition monitoring of building structures during earthquakes using a wavelet-based analysis technique’,
Proceedings of the Sixth International Conference on Condition Monitoring and Machinery Failure Prevention Technologies, Dublin, Ireland, 23-25 June 2009, Paper No. 247.
Goggins J. M., Broderick B. M., Elghazouli A. Y. ’Investigation of the performance of concentrically braced steel frames during earthquakes’,
Proceedings of 6th International Conference on Steel and Aluminium Structures ICSAS'07, Oxford, England, 24-27 July 2007, Paper No. 068.
-
Jamie Goggins, Brian M. Broderick, Ahmed Y. Elghazouli ’RECOMMENDATIONS FOR THE EARTHQUAKE RESISTANT DESIGN OF BRACED STEEL FRAMES’,
Proceedings of First European Conference on Earthquake Engineering and Seismology, Geneva, Switzerland, 3-8 September 2006, Paper No. 966.
-
Jamie Goggins, Brian M. Broderick, Biswajit Basu, Ahmed Y. Elghazouli ’EQUIVALENT TIME-VARYING STIFFNESS OF BRACED FRAMES USING WAVELET ANALYSIS’.
Proceedings of First European Conference on Earthquake Engineering and Seismology, Geneva, Switzerland, 3-8 September 2006, Paper No. 955.
-
Goggins J., Basu B., Broderick B.M., Elghazouli A.Y. ’Earthquake damage detection in concentrically-braced frames using wavelet analysis’.
Proceedings of STESSA 2006 “Behaviour of Steel Structures in Seismic Areas”- 5th International Conference, Tokyo Institute of Technology, Yokohama, Japan, August 14-17, 2006, Paper No. 197.
-
Jamie Goggins, Biswajit Basu, Brian M. Broderick, Ahmed Y. Elghazouli . ’Wavelet-based analysis of concentrically braced frames subjected to earthquake loading’.
Proceedings of the 3rd European Workshop on Structural Health Monitoring, Granada (Spain), July 5-7, 2006.
-
Goggins J. M., Broderick B. M., Elghazouli A. Y. ’Seismic behaviour and design of bracing members’.
Proceedings of EUROSTEEL 2005 Conference, Maastricht, 8 –10 June 2005, Paper No. 424.
-
Elghazouli A. Y., Broderick B. M., Goggins J. M., Mouzakis H., Carydis P., Plumier A., Bouwkamp J. ’Shake-Table Testing and Seismic Performance Evaluation of Bracing Members’.
Proceedings of 13th World Conference on Earthquake Engineering, Vancouver, 1-6 August 2004, Paper No. 2651.
-
Broderick B. M., Elghazouli A. Y., Goggins J. M. ’Cyclic Behaviour of Hollow and Filled Axially-Loaded Members’.
Proceedings of 13th World Conference on Earthquake Engineering, Vancouver, 1-6 August 2004, Paper No. 2589.
-
Broderick B. M., Goggins J. M., Elghazouli A. Y. ’Experimental behaviour of hollow and filled RHS bracing members under earthquake loading’.
Proceedings of COMPOSITE CONSTRUCTION V, ASCE, Kruger National Park, South Africa, 18 to 23 July, 2004.
-
Goggins J. M., Broderick B. M., Lucas, A. S. ’Cyclic response of cold-formed hollow steel bracing members’.
Proceedings of The Second International Conference on Structural Engineering, Mechanics and Computation, Cape Town, South Africa, 5-7 July 2004, Paper No. 269.
-
Goggins J. and Broderick B.M. ’The determination of a suitable mortar mix design to fill slender hollow sections’,
In Proceedings of Colloquium on Concrete Research in Ireland, Belfast, P.A.M. Basheer & M.I. Russell (editors), pp. 107-116, The Queen’s University of Belfast, 2003.
Other
Non-peer reviewed publications
Goggins J.: ’NUIG student project in Africa highlights practical value of education’,
The Engineers Journal, Vol. 64, Issue 4, May 2010 [article].
Goggins J., Creedon R., Fitzgerald E., Fogarty J., Manton R., Kerins A.: ’The role service based-learning can play in engineering education for the benefit of students and communities in rural Africa’,
NUI Galway Inaugural Conference on Service Learning, 9 March 2010, NUI Galway, Ireland.
Goggins J.: ’NUI Galway links up with voluntary organisations to work on projects in Africa’,
The Engineers Journal, Vol. 63, Issue 8, October 2009 [article].
Goggins J.: ’The engineer of the future - a specialist or a generalist?’,
The Engineers Journal, Vol 62, Issue 9, Nov 2008.
Published reports
-
’Seismic Behaviour of Steel and Composite Bracing Members: Shake Table and Static Tests’,
Joint FP6 Project Report, September 2003, Edited by A. Y. Elghazouli. ECOLEADER Project Report submitted to the European Commission.
Thesis
-
Goggins J., ’Earthquake resistant hollow and filled steel braces’.
PhD Thesis. Trinity College, University of Dublin, 2004.
Technical Notes
-
Goggins J.: ’Technical Note on Seismic Design’, Buro Happold Ltd., 2006.
-
Goggins J.: ’Precedent study of Tall Buildings in Seismic Zones’, Buro Happold Ltd., 2006.
|