Headset Overview


CS510 Wireless Headset System


Headset set up:

1. Connect the Power and EHS cable

Plug one end of the power supply into the power jack on the back of the base and the other end into a working power outlet. The Power On LED will be solid white. The EHS Cable will connect as shown in the diagram below.

Connection of headset to phone


1. If your desk phone has a volume control set it to mid-range.

2. Look at the bottom panel of your base and make sure the default settings are correct. Set your desk phone’s volume. listening volume dial ( ) = 2 and speaking volume dial ( ) = 2 configuration switch = A desk phone volume = mid-range

3. Remove the handset from the desk phone cradle.

4. While wearing your headset, press the call control button on the headset.

5. If you do not hear a dial tone, adjust the configuration switch (A-G) until you do

2. Charge the Headset

Place the headset in the charger cradle. The charging LED on the base will flash green when charging and turn solid green when the headset is fully charged. Charge for at least 20 minutes prior to the first use. A full charge takes 3 hours.

3. Make a test call

Dial a test call from the desk phone. If needed, fine-tune the volume with the headset volume controls. You can also adjust the desk phone speaking and listening volumes on the bottom of the base

Bass Button functions

Base buttons 0on the headset

1. Subscription Button

(Not needed)

2. Wideband/Narrowband Audio Switch

(Not needed)

3. Auto Answer Switch

Auto answer saves a button press to establish the radio link between headset and base. When auto answer is set to black you must press the headset call control button to answer an incoming call.